English: Diagram showing three kinds of glass-to-metal seals, for use in vacuum tubes. Scale: the lengths shown are each 6 inches (15.25 cm).
Excerpt of the original discussion (pp. 10-11):
"The third type of seal and the most important in connection with the current problem is the tube seal shown in Fig. 5. This furnishes the means of joining metal and glass tubes end to end and is used in the water-cooled tube to attach the anode to the glass cylinder which serves to insulate the other tube elements. As in the case of the disc seal, it can be made either with the edge of the metal not in contact with the glass, as shown in A, or with the metal sharpened to a fine edge which is in contact with the glass. The glass may be situated either inside or outside of the metal, see B and C.
The first thermionic tubes in which these seals were embodied were made of copper and were designed to operate at 10,000 volts and to give about 5 k. w. output."
Toto dílo je ve Spojených státechvolným dílem. To platí pro americká díla, jejichž autorská práva vypršela, často proto, že byla poprvé zveřejněna před 1. lednem 1929. Podívejte se na tuto stránku pro další vysvětlení.
Tento obrázek nemusí být volným dílem mimo Spojené státy; to se týká zvláště těch zemí a oblastí, kde pro americká díla neplatí pravidlo kratší doby, jako jsou Kanada, Kontinentální Čína (ne Hong Kong nebo Macao), Německo, Mexiko a Švýcarsko. Tvůrce a rok publikace jsou nezbytné informace a musí být uvedeny. Viz Wikipedie:Autorské právo pro více informací.
Popisky
Přidejte jednořádkové vysvětlení, co tento soubor představuje
Tento soubor obsahuje dodatečné informace, poskytnuté zřejmě digitálním fotoaparátem nebo scannerem, kterým byl pořízen. Pokud byl soubor od té doby změněn, některé údaje mohou být neplatné.